Your search returned 465 items.
For this, you will have to assign the circuit breaker of interest inside of the relay logic block (RelLogdip). Status of each assigned circuit breaker can be accessed by defining "_SWTx" Input Signal.…
Yes, this is possible. For this task, we will have to make changes in the relay model itself. This means we will have to add a second current transformer (CT) device, measurement block and to add…
The objective is to limit the active power setpoint of a generator depending on the voltage measurement at its terminal. For this functionality, a QDSL-Model is attached to this ticket with the…
For this task: 1) Navigate to the relay type of interest inside the data manager. 2) Create a new relay object (ElmRelay) and name it "default". 3) Assign the relay type to this new relay. 4) Once the…
An example is attached, where the current source is controlled via a DSL block. Three different possibilities are included in the example.Import the project in PowerFactory and run an EMT Simulation.…
Using the measurement file to read time series will give you a simulation time referenced value. An event based shift of this curve is not possible. The attached project shows another approach on…
Acharacteristic is assigned by an invisible object. This object is of the class "ChaRef" and it is stored IN the object you want to apply the characteristic to. Assumed that the load is the target…
The management of the result boxes is done via the SetLevelvis object, stored in the settings folder of the graphic. The needed command is SetLevelvis.AdaptWidth() but before are two configuration…
Tags
You can change the default frequency for the grid (ElmNet) as follows: 1. Log on as Administrator 2. Go to Database => Configuration => Class Templates 3.) Create an instance for ElmNet and set…
Harmonic load flow calculation and frequency sweep calculations require detailed models of lines that are also representative for higher frequencies. For that purpose, overhead lines and cable systems…